Blackmagic Design has released Fairlight Live 1.1.1, a free update to its software-based live broadcast audio mixer. The release adds support for the Fairlight Live Audio Panel 20 and Audio Panel 40, allowing the application to work with the company's new dedicated control surfaces. It also adds factory templates for the new ATEM Constellation IP switchers and custom screen mapping for multi-screen Fairlight panels.

The maintenance work is concentrated around operator control and signal management. Blackmagic lists improved audio I/O management and error reporting, better bidirectional monitoring controls in the patching matrix, persistent file-selector paths in the cue player, dated snapshots and a do-to-all or selected action in bus management. Panels can now enter standby after inactivity and return all screens to their home view when a project loads.

Several corrections affect workflows that matter on air. The notes say 1.1.1 addresses an ST 2110 sender issue in the panel utility, a problem with initialising mix-minus outputs, channel selection in the index, layer setup and a patching-matrix view that could jump back to the top. The update does not redefine Fairlight Live's architecture, but it closes practical control and routing gaps around a mixer designed for large channel counts, redundant operation and SMPTE ST 2110 audio.

Blackmagic has not published a detailed compatibility matrix for every supported computer, network interface, ATEM model or third-party 2110 device in the short release notes. The company also provides no measurements for fixed sender behaviour, failover timing, panel response or maximum tested channel count in 1.1.1. Facilities should back up show files, confirm panel and switcher firmware prerequisites, and validate PTP, mix-minus, monitoring and redundancy behaviour in a non-air environment before moving a production system.